I do not have a spare channel in my receiver. I wonder how I would best install the voltage monitor.
From the RMG website - Picture
This animation shows the Flash installed in the hatch of an IOM RC yacht. The gasket seal of the plastic container lid has been cut out and the display stuck to the transparent lid with clear Silicone. In this instance the Flash is connected into the power supply lead between a 6 cell battery pack and the winch. It's displaying 8.23 Volts.
me - Before I start cutting wires, what is the best way to connect it into the power supply lead between the battery and the winch? Add a Y in there so I have an added plug for the monitor? That seems obvious, but I thought I would ask. Seems like it would easy to put the words "add a Y" in the instructions rather than say "connected into the power supply lead". To me in order to connect something in the power supply lead without cutting any wires I would need an in and an out plug on the monitor so it could be installed in series.
I feel like I am not seeing something that should be obvious.
I tried to find the voltage monitor on the EC12.info site but I could not find it even using search. I think I have seen it there. Maybe not.
As always thank you in advance.
Scott