I was surprised to see that the setup instructions are totally different for the new 280DL that I just bought versus even the previous 280DL that I had bought.
The new instructions have the xmtr turned on and the winch turned off and then in step 2 the winch goes into setup mode by turning the winch on, waiting for the beeps and then pushing the RX lead plug into the RX. I have a hard time understanding what words mean and could not figure out what an "RX lead plug" is to I eventually got out my old book, and successfully set up and increased the rotations of the winch.
I just write this because this might be a recent development that few people know about. And I am curious what Bob might have to say about it.
I think I now know what the instructions say/mean, so for the next 280DL I will again try to follow the new instructions as written.
Scott