I purchased a water proof switch from GBMY. It has 3 poles, I'll call A, B, C.
In referencing the wiring diagram at( http://www.ec12.info/images/rmg_dr2.gif) it lists a DPDT switch with 6 poles. For discussion I'll label them:
#1 top left - Red to RMG winch
#2 top right - Red to Receiver
#3 Center left - Red to Battery
#4 Center Right - Jumper to #3
#5 Lower left - not used
#6 Lower Right - not used
Question (finally) - Can I pigtail the red wires going to #1 and #2 together and connect to my Pole A? Can I connect the #3 to my Pole B? Seems like it should work but I'm no electronic wiz.
Thanks,
Larry
York, Maine