Radios, Servos, Winches, Batteries
All things that can make sparks
Moderators: Capt. Flak, bigfoot55, Chuck Luscomb
by s vernon » Wed May 04, 2005 5:12 pm
I bought a project boat a while back. It has a Houtz Tower which I figure I will use until I get ambitious and make a blade mount.
I notice that it is not the stiffest thing in the world. Twists a bit under rudder or winch pressure. Any thoughts about how to stiffen it up? I figure I might CA some CF rods in compression between the mount and the cockpit wood.
Or?
Thank you,
Scott
-
s vernon
-
- Posts: 471
- Joined: Mon Sep 15, 2003 9:18 pm
- Location:
-
by kahle67 » Wed May 04, 2005 8:43 pm
I have noticed that problem as well. The rudder servo can twist it all over the place. I keep it all low on a piece of aluminum angle.
RK
-
kahle67
-
- Posts: 1453
- Joined: Thu Sep 18, 2003 3:39 pm
-
Return to Electronics
Who is online
Users browsing this forum: No registered users and 18 guests