super short phillips screwdriver for servo arm screws
Posted: Thu May 14, 2015 8:51 am
I do not know why I did not think of this years ago.
I needed to remove the rudder servo arm screw which is horizontal with very limited access - near the side of the hull. I used my smallest phillips screwdriver (hex ratchet tool) bit and was able to break the screw loose and remove it. I masking tape the screw to the bit to reinstall.
I figure there might a lot of people with the same problem.
Scott
I needed to remove the rudder servo arm screw which is horizontal with very limited access - near the side of the hull. I used my smallest phillips screwdriver (hex ratchet tool) bit and was able to break the screw loose and remove it. I masking tape the screw to the bit to reinstall.
I figure there might a lot of people with the same problem.
Scott