by Chuck Luscomb » Wed Sep 30, 2009 7:15 pm
Bob,
I use the same set up as your describing and at first had the same problem.
A few possible reasons for this...
1-loose connection someplace.
2-Low Battery that tests like it is good. Do you have a load tester?
3-You have a "Standard" RMG wiring set up which places the AR6000 getting its power through the RMG(No battery connected directly to the AR6000)
If you are using a 6v. pack, the RMG steps this down to 4.8v when it supplies the RX. No matter what happens, you should change this to the new set up using a "splitter" after the on/off switch that supplies power to both the RMG and the RX at the same time. This way both the RMG and the RX get the full 6v supply. You must also remove the center "red" power wire from the plug coming from the RMG to the Rx. Simply shrink tube the pin and secure it to its own wire. This will leave the signal wire (orange) and the ground (brown) still connected to the RX.
4-Reprogram you winch and set your "battery monitoring" to Off.
Hope this helps,
Chuck
#84